The IR-5000 includes these items:
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase.
This is a no hassle warranty with no mail in warranty card needed. This warranty
does not cover damages in shipment, failures caused by other products not
supplied by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only to the
original purchaser, and a purchase receipt, invoice, or other proof of original
purchasedatewillberequiredbeforewarrantyrepairsareprovided.
Power supply
1 - hole mount
Mail in service can be obtained during the warranty period by calling (800) 840-
0288 toll free. AReturnAuthorization number must be obtained in advance and
canbemarkedontheoutsideoftheshippingcarton.
This warranty gives you specific legal rights and you may have other rights
(which vary from state to state). If a problem with this product develops during or
after the warranty period, please contact ChannelVisionTechnology, your dealer
oranyfactory-authorizedservicecenter.
2 - IR-3002 emitters
500-149 rev B
1 - tabletop mount
4 - IR emitter holsters
How IR repeating works
Specifications
1 - IR receiver holster
The IR receiver is wired to
the IR hub which routes the
signal to IR emitters
Specifications: (typical)
IR receiver head
36”
Power Supply Voltage:
IR Freq. range supported:
IR pickup range:
8 - 12 VDC
30 kHz - 60 kHz
Point an
IR remote control
at the IR receiver
40 ft. @ 38kHz, 25 ft. @ 56kHz
IR receiver head dimensions: 0.65” x 0.35” x 0.25”
IR emitter outputs:
Color:
4
Black
Features:
!
!
!
!
Plasma Proof IR receiver
4 IR emitters
Status LEDs for power and IR signal indication
Versatile mounting accessories included
Specifications subject to change without notice.
LED Status indicators:
Power and IR data
And the emitter
repeats the IR signal
in front of the component.
CD player
DC Power input
4 IR emitter outputs
Be sure the emitter is attached directly over the component’s IR receiver.
To locate the IR receiver, shine a flashlight into the unit and look for the
sensor.
|